Skip to content
MechAMS logoMechAMS

Heads up, a major MechAMS update is landing end of August with new pricing and better support. You might want to hold off buying until then.

Getting Started

Installation

Print the parts and assemble per the setup guide. PLA or any other rigid filament is fine for everything except the belt and the filament drive gears, which need TPU 95A. Print the test jig first and check the fit before committing to a full set.

  1. Print and prepare parts.
  2. Mount the toolhead mechanism and install the topbar slot bank.
  3. Load 4 filaments out of the box, or up to 8 with Y-splitters, and align feed paths.
  4. Run the generator setup and tune each slot X position.